Hoover SteamVac F5857-900 Manual Del Propietário página 6

Genera[ operation
Operate deep cleaner only at voltage specified on data plate
on back of cleaner,
ON/OFF pedal
ON/OFF
PEDAL
Plug deep cleaner into a properly grounded outlet.
Step on pedal to turn deep cleaner on. Step on pedal again to
turn deep cleaner off.
Handle release pedal
RELEASE
PEDAL
Step on pedal to lower handle to operating position. Handle
does not lock into a single position but "floats" to allow conve-
nient operation,
When the recovery tank (lower tank) is full, the automatic "shut-
off"mechanism will shut off the deep cleaner suction.
At that time, the red or yellow float disk will rise to the top of the
recovery tank lid (see illustration). The deep cleaner will "no
longer pick up dirty solution and the motor sound will become
noticeably higher in pitch.
When this happens, turn deep cleaner off and empty recovery
tank before continuing use.
Check clean solution tank also; it may need to be refilled.
To transport
Turn deep cleaner off before transporting.
To move your deep cleaner from room to room, put handle in
upright and locked position, tilt deep cleaner back on wheels,
and push forward.
The deep cleaner may also be lifted by placing a hand under
the upper clean solution tank handle as shown.
Agitator speed selector
Your 'SteamVac' deep cleaner has three agitator brush settings.
HI - for normal cleaning of carpet and bare floors
LO - for gentle cleaning of carpets and bare floors
OFF - for cleaning carpets and bare floors when
brushing is not desired. (Such as when picking up
liquid spills. See page 10.)
Slide selector button to the desired setting before cleaning.
6 General operation - Agitator speed selector