Descargar Imprimir esta página

Hoover SteamVac F5857-900 Manual Del Propietário página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

Replace cap. Rotate cap clockwise until it locks in place.
Cap must be locked in place for proper performance and to
revent leaking.
/
Position bottom of tank into unit and press on tank handle to
snap tank into place.
Recovery
tank
(tower
tank)
The recovery tank holds the dirty solution that is picked up from
the carpet.
When the recovery tank is full, the automatic "shut-off" will
engage (see page 6) and the tank must be emptied.
How
to empty
S ! JIL//
Turn deep cleaner off and disconnect from electrical outlet.
To prevent possible leaking, remove clean solution tank by
pressing down on tank handle and pulling forward; set tank
aside (do not set tank on furniture).
PEDAL
LATCH
Step on handle release pedal and lower handle until it rests on
the floor,
If cleaning stairs or upholstery, remove hose by reversing
procedure as shown on page t2.
Rotate recovery tank latches outward (one on each side of tank),
Lift tank off of deep cleaner and carry it to a sink or drain.
REAR OF
TANK
Unlatch back part of tank lid and remove lid.
Empty tank, Pour dirty water out from the rear of the tank.
TABS
The lid replaces in a hinge-like manner. Position the front of
lid under tabs on front of tank
Rotate lid down onto tank. Make
sure that the lid is secure on all sides before placing tank on
cleaner.
LATCH"
For full suction, it is important that the
recovery
tank lid is properly
secured before
cleaning.
Replace tank and press down to ensure that it is properly seated
in place.
Rotate latches (one on each side of tank) inward to lock tank
in place.
To continue cleaning stairs or upholstery, replace hose as
shown on pages 11 and 12.
Raise handle to upright position and replace upper clean
solution tank.
8 Filling solution tank - Emptying recovery tank

Publicidad

loading

Este manual también es adecuado para:

Steamvac f5858-910Steamvac f5858-920