Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE YOUR
SNOW
THROWER
TO STOP
YOUR
SNOW
THROWER
• To stop the auger, release the auger
control bar.
NOTE: If the auger continues
to creep, refer
(To Adjust Auger Control Cable paragraph on
page !2).
• To stop the engine, turn key to the OFF
position.
TO CONTROL
SNOW
DISCHARGE
• Turn the chute control rod to set the
direction
of the snow throwing.
• Loosen the wing knob on the chute
deflector and move the deflector to set
the distance.
Move the deflector (UP) for
more distance, (DOWN) for less distance.
Then tighten the wing knob (See figure
below).
Knob
"TO USE
AUGER
PROPEL
ACTION
• Squeeze the auger control bar down
against the upper handle to allow the
auger to turn.
• To propel forward, raise the handle to
allow the rubber auger blades to contact
the ground (See figure below).
Blades
NormaE
ig
be_o CAUTION:
Read owner's manual
re operating
machine. Never direct
discharge toward bystanders,
Release the
auger control bar and stop the engine
before unclogging
discharge chute or auger
housing and before leaving the machine_
BEFORE STARTING
ENGINE
WARNING:
Experience
indicates that
alcohol blended fuels (called gasoho_ or
those using ethanol or methanol)
can
attract moisture which leads to separation
and formation
of acids during storage,
Acidic gas can damage
the fuel system of
an engine while in storage. To avoid engine
problems,
the fuel system should be
emptied before storage for 30 days or
longer. Start engine and let it rununtil
fuel
lines and carburetor
are empty. Use
carburetor
bowl drain to empty residual
gasoline from float chamber
(See figure in
Storage section, page 16), Use fresh fuel
next season. (See Storage Instructions
on
page 16 for additional
information).
Never use engine or carl_uretor cleaner
products
in the fuel tank or permanent
damage
may occur
FILL
GAS
The two cycle engine used on this snow
thrower requires a mixture of gasoline
and
oil for lubrication of the bearings
and other
moving parts_ The correct fuel mixture ratio
is 40:1 (3.2 oz. oil per gallon of gas - see
Fuel Mixture Chart). Gasoline
and oil must
be pre-mixed
in a clean gasoline
container.
Always use fresh, clean, unleaded gasoline.
FUEL MIX CHART (Mlxture
40:1)
U.S.
IMPERIA L
S. L (METRIC)
o,,GAs OIL G sI OiL
i Gal 3,2 oz, 1 Gal 3.7oz,
4 Liters
100ML
GASOLINE
AND OIL MIXTURE
Mix gasoline and oil as follows:
• Pour 1 U.So cluart of fresh, dean,
unleaded automotive
gasoline to a gallon
gasoline container.
.
Add &2 oz of clean, high quality,
Craftsman
two-cycle
oil into the gasoline
container
(One 3.2 ounces of oil pro-
vided)_
Publicidad
