Publicidad
Idiomas disponibles
Idiomas disponibles
IQ EV Charger User Manual
EVSE mounting for solid-wall construction
•
To secure the unit in concrete, pre-drill appropriately sized holes
and use multi-set or wedge anchor hardware at both mounting
points.
•
To secure the unit in brick or stone, pre-drill appropriately sized
holes and use sleeve anchors at both mounting points.
•
The included plastic angle washers can be oriented to allow bolts
to be fastened at an angle or perpendicular to the mounting
surface.
NOTE: There are two different sets of plastic angle washers
included. Select those washers that best accommodate the
mounting hardware "angle of attack" and orient them
accordingly.
NOTE: If the head of the mounting hardware is smaller
than the ⅜" (1 cm) plastic angle washer aperture, an
additional flat washer must be placed between the plastic
angle washer and the mounting hardware.
•
Machine screw size ¼"- 20 hardware is recommended for
mounting the EVSE. Screw shafts of at least 2" (5.1 cm) are
recommended. The EVSE plastic angle washer hole size is ⅜"
(1 cm) in diameter, make sure the screw heads are of a larger
diameter. Place appropriately sized washers between the screw
heads and the IQ EV Charger enclosure mounting flanges.
Figure 11: Mounting EVSE to a solid-wall
17"
26
Publicidad
