Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING THE CONNECTOR HOLSTER
(SAE J1772/NACS)
A connector holster is included with your shipment
(J1772 or NACS) to provide a convenient protective housing for
the connector head when it is not in use.
•
A connector holster should be installed in a location to give
users easy and safe access to the connector.
•
•
For indoor installation, mount the connector holster between
18" (45.7 cm) and 48" (122 cm) above the ground or grade.
•
•
For outdoor installation, mount the connector holster between
24" (61 cm) and 48" (122 cm) above the ground or grade.
•
The SAE J1772 connector holster has two vertically aligned
mounting holes spaced 5.45" (13.8 cm) apart, one each on the
enclosure top and bottom. Use a ruler or template to mark hole
locations on the mounting surface.
•
The vertical alignment of the IQ EV Charger and connector
holster mounting holes allows for conveniently mounting both
components onto the same post or wall structure. For example,
the holster may be mounted directly above the EVSE.
•
Place the connector holster such that both mounting holes can
take advantage of solid structural framing inside the wall or a
strong wall surface such as plywood.
•
A set of exterior wood screws and stainless steel washers are
included to mount the connector holster to a wooden surface.
•
For mounting to a solid surface such as concrete, brick, or
stone, alternate hardware may need to be procured. Examples
of solid-wall mounting hardware include multi-sets, wedge
anchors, and sleeve anchors. Use the type of mounting
hardware most appropriate for the supporting structure.
IQ EV Charger User Manual
27
Publicidad
