INSTALLATION
I
30"
AL FUEL SLI
UCTION
E-I
E
iNSTALLATION AND SERVICE MUST BE PERFORMED
BY A QUALIFIED
iNSTALLER.
IMPORTANT:
SAVE FOR LOCAL ELECTRICAL
iNSPECTOR'S
USE.
READ AND SAVE THESE iNSTRUCTIONS
FOR FUTURE REFERENCE.
United States
Canada
Refer to your serial
plate for applicable
agency certification.
if the information
in this manual
is not followed
exactly,
a fire
or explosion
may result
causing
property
damage,
personal
injury or death.
FOR YOUR SAFETY:
m
Do not store
or use gasoline
or other
flammable
vapors
and liquids in
the vicinity
of this or any other appliance.
WHAT TO DO iF YOU SMELL
GAS:
•
Do not try to light any appliance.
•
Do not touch
any electrical
switch;
do not use any phone in your
building.
•
Immediately
call your gas supplier
from
a neighbor's
phone.
Follow the
gas supplier's
instructions.
•
if you cannot
reach your gas supplier,
call the fire department.
Installation
and service
must
be performed
by a qualified
installer,
service
agency
or the gas supplier.
Table of Contents
Important Safety Instructions.......................................
2-3
Cabinet & Product Dimensions ....................................
3-4
To Avoid Breakage ..........................................................
5
Before Starting ................................................................
6
Cabinet Construction ...................................................
6-7
Provide an Adequate Gas Supply ...................................
7
Seal the Openings ..........................................................
7
Factory Connected Power Supply Cord (Canada only) ...... 7
Power Supply Cord Kit (U.S.A.) ........................................... 7
Access to Terminal Block & Grounding Strap ...................... 8
Electrical Connection to the Range ................................ 8-10
Connect the Range to the Gas Supply .................... 10-11
LP/Propane Gas Conversion .........................................
11
Moving the Appliance for servicing and Cleaning .......... 11
Range Installation ....................................................
11-12
Leveling the Range .......................................................
12
Decorative Rear Trim Installation .................................
13
Check Operation ......................................................
13-14
When All Hookups are Complete ..................................
14
Model and Serial Number Location ..............................
14
Before You Call for Service ...........................................
14
Anti-Tip Brackets Installation ...................................
15-16
important
Notes to the Installer
1. Read all instructions contained in these installation
instructions before installing range.
2. Remove all packing material from the oven and the
drawer compartments
before connecting the gas and
electrical supply to the range.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
5. Note: For operation at 2000 ft. elevations above see
level, appliance rating shall be reduced by 4 percent for
each additional 1000 ft.
important
Note to the Consumer
Keep these instructions with your owner's guide for the
local electrical inspector's use and future reference.
P/N 318201634 (1306) Rev. A
Appliances
Installed
in the state of
Massachusetts:
This Appliance can only be installed in the state of
Massachusetts
by a Massachusetts
licensed plumber or
gasfitter.
This appliance must be installed with a three (3) foot / 36
in. long flexible gas connector.
A"T" handle type manual gas valve must be installed in
the gas supply line to this appliance.
_Cold
temperature can damage the
electronic control. When using the appliance for the
first time, or when the appliance has not been used
for an extended period, be certain the unit has been
in temperatures above 32°F (0°C) for at least 3 hours
before turning on the power to the appliance.
English - pages 1-16; Spanish - pages 17-32; French - pages 33-48
Printed in United States