TrolMaster TCS-1 Manual Del Usuario página 2

INSTRUCTIONS
Install the Tent-X on a wall using the included back plate that comes in the package with the controller. It is
a simple fixed wall bracket. Simply release the controller from the bracket by pulling the controller from the
bracket, then mount the bracket on the wall using screws. You can then place the controller back into the
bracket by simply pushing the controller into the bracket. It will lock itself into place. Then you can start
installing and connecting your sensors and device modules to the TCS-1 using our standard RJ12 cables.
The interconnecting RJ12 communication cables come in various lengths. It's crucial to choose the right
length that suits your application. When purchasing the TCS-1 TENT-X Control System, you'll receive a RJ12
cable set consisting of a 4ft and 16ft RJ cable and Y-splitter as part of the package. Each device module
and optional sensor you purchase will also come with the standard RJ12 cable set. Additional ECS-1 cable
sets can be purchased.
1. Sensor Connections
ALL of the sensors used with the TENT-X will be connected to the RJ12 port labeled SENSORS, at the
bottom of the unit. First, connect an RJ12 cable to the port, then connect the other end to either a Y-splitter
or TrolMaster' s splitter hub (SPH-1). If using the Y-splitter, you can connect the first sensor and then use
additional Y-splitters to add each additional sensor. When connecting multiple sensors, it can be easier to
use a single 8-port SPH-1 instead of multiple Y-splitters. Below are all of the sensor types that can be
connected to the TCS-1 and the maximum number that can be connected.
02