Blauer. H.T. DJ Manual Del Usuario página 9

Removing the visor (4)
● 1 Rotate the left mechanism cover clockwise
and the right cover counter-clockwise.
● 2 Once you hear a click the covers are
unblocked and you can remove them.
● 3 Unscrew on both sides the Allen screws
using an Allen key nr. 4 (not supplied).
● 4 Remove the visor.
Replacing the visor
● 1 Put the visor into its position.
● 2 Screw the Allen screws on both sides.
● 3 Position the left cover and rotate it counter-clockwise until you hear a click.
Repeat on the right side rotating the cover clockwise.
● 4 Make sure that the visor opens and closes correctly before use.
9
Sun shield control (6)
The sun visor lowers moving the sun
shield slider from the top down.
Sun shield change (2)
● 1 Pull the external visor up.
● 2 Lower the sun shield.
● 3 Release the Sun visor by pulling it out from the ratchet system at point A
first on one side and then on the other.
To mount the new sun visor in the helmet make sure that the attachment
point on the ratchet is lowered, then insert the visor first on one side and
then on the other. Make sure that the visor is well inserted before use.
WARNING:If you are not sure that you properly replaced the visor, do not use your
helmet. The visor could suddenly and without warning become detached from the
helmet while riding, causing you to lose control of your motorcycle, resulting in an
accident, personal injury, or death. Contact your retailer for any assistance or advice.
Do not ride with an open visor and do not try to open or adjust the visor while riding.
Tinted or dark visors should never be used at night or under poor visibility conditions
as they reduce your ability to see. If your visor no longer provides you with clear
visibility after a period of service, you must immediately replace it. Never ride if your
visor is scratched, dirty, foggy or with your vision obscured in any way. Always ride
with perfect visibility.