Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning of powder filter, prefilter
and damper
Clean out the filters and damper from time to time.
Clogged filters and damper may result in poor suction
performance.
Regularly clean out the accumulated dust of filters and
damper.
Occasionally wash the powder filter, prefilter and
damper in water, rinse and dry thoroughly in the shade
before use. Never wash them in a washing machine.
Fig.39
NOTE: Do not rub or scratch the powder filter, the
prefilter and the damper with hard objects such as a
brush and a paddle.
NOTE: The filters wear out in course of time. It is
recommended to have some spares for them.
Installing powder filter and prefilter
NOTICE:
The powder filter and prefilter can pick
up both dry dusts and wet dusts. Make sure that
the water level sensors activate properly to pre-
vent the powder filter breakage.
Hook the edges of the filter unit to the top plate, and
then lower the knob.
Fig.40
► 1. Edge 2. Knob
1
2
20 ENGLISH
NOTICE:
Before using the powder filter, make
sure that prefilter and damper are used together. It
is not allowed to install powder filter alone.
Assembling the filters
When you get the filters separately, assemble them as
shown in the figure.
Fig.41
► 1. Powder filter 2. Damper 3. Prefilter
Installing the filter unit
After installing the filters to the top plate, hook the holes
of the filter unit to the U-shaped parts of the inner cover.
Then, lock the latch as shown in the figure.
2
1
3
Fig.42
► 1. U-shaped part 2. Hole 3. Latch
1
2
3
2
Publicidad
