cecotec ENERGYSILENCE AERO 5200 LIGHT WHITEWOOD Manual De Instrucciones página 40

ENGLISH
- Insert the 3P connector from the motor light into the 3P MOTOR socket on the receiver.
- Connect the yellow/green 1P connectors of the motor and the mounting bracket.
4. OPERATION
Remote control
Fig. 10
- Reconnect the mains supply from the electrical switchboard in the house.
- Remove the battery-compartment cover of the remote control, insert the batteries, and
replace the cover.
Note:
- The remote control is powered by two AAA 1.5 V batteries.
- If the fan is not to be used for a long period of time, store the remote control in a dry place
where it will not be exposed to heat or direct sunlight. Also remove the batteries.
The remote-control buttons control the speed and light of the fan.
Fig. 10 key
1. Power button
2. Clockwise oscillation button
3. Switch off the fan only
4. Light button 3 shades are available and can be activated by a short press.
5. Counterclockwise oscillation
6. Breeze mode. The fan will automatically adjust the speed and direction of the blades
intermittently.
7. Speed setting button 6 speeds available.
8. Timer button.
2 hrs: the fan will automatically switch off after two hours of operation.
4 hrs: the fan will automatically switch off after four hours of operation.
8 hrs: the fan will automatically switch off after eight hours of operation.
Pairing between remote control and receiver
Press the power button for 30 seconds and then, press any button on the remote control for 5
seconds. You will hear a beep, which means that the pairing has been completed successfully,
so you can use the remote control normally.
NOTE: be sure to press the power button for 30 seconds before pairing the remote control,
otherwise you will not be able to pair it.
40
ENERGYSILENCE AERO 5200 LIGHT WHITEWOOD / BLACKWOOD