Tornado Tempest Manual De Operaciones Y Mantenimiento página 11

Replacing / adjusting the sealing strips
Sealing strips
Side sealing strips
Front sealing strip
Rear sealing strip
Front sealing strip
1
Side sealing strip
2
Rear sealing strip (not adjustable)
3
Fastening
4
Waste container
5
1. Release the fastening of the sealing strips.
2. Set the sealing strip by shifting it in the elongated holes.
a Refer to the table for the values.
3. Once the settings are correct, fasten the sealing strips.
Adjustment values
Distance from floor .04 -
.08 in
Distance between sealing
strip and retaining plate 1.1 -
1.2 in
Not adjustable
Troubleshooting guide
Note
Contact customer service for all malfunctions not listed!
Roller brush / side brush do not run or run
 Turn on the On/Off switch (position I).
 Charge the battery.
 Engage the battery correctly.
 The electronics switched off the device due to an over-
load (LED flashes). Observe when switching on again:
a Switch off the device using the On/Off switch.
b Raise the roller brush by lifting the twist grip and turn-
ing it all the way up in an counterclockwise direction.
c Switch on the device using the "On/Off switch".
 Check roller brush / side brush for wrapped straps.
 Check the belt.
 Fully close the cover (cover switch).
Dust when sweeping / insufficient suction
 Empty the waste container.
 Check/replace the seals on the filter box and waste con-
tainer.
 Check / clean / replace dust filter and pre-filter.
a Check that the dust filter and pre-filter are fitted cor-
rectly.
b Clean the dust filter and pre-filter if they are lightly con-
taminated.
c Replace the dust filter and pre-filter if they are dam-
aged or highly contaminated.
 Check / adjust / replace the sealing strips for wear and
tear.
 Blower defective, contact customer service.
Sweeping performance not satisfactory
 Correctly adjust the sweeping level of the roller brush
and side brush using the adjustment option.
 The roller brush and side brush are too worn out, re-
place them.
 Check the sealing strips for wear and tear, adjust / re-
place if necessary.
English
incorrectly
performance
11