Descargar Imprimir esta página

cecotec ENERGYSILENCE AERO 5600 AQUA CONNECTED Manual De Instrucciones página 44

Ventilador de techo

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
ENGLISH
3. PRODUCT ASSEMBLY
General assembly instructions
-
If you hang the fan on a hook, the latter must withstand at least 100 kg.
-
To prevent personal injury and damage, make sure that the location where the appliance is
going to be installed allows a 2.3-metre clearance from the blades to the floor and a 76-cm
clearance from the blades to any wall or object. Fig. 2
-
Make sure that the building structure can hold the full weight of the fan.
-
This fan can be installed on a normal or vaulted ceiling with a downrod. The hanging length
can be extended by using a longer downrod.
Assembly according to the type of ceiling:
-
Wooden ceiling. Fig. 3
-
Concrete ceiling. Fig. 4
To assemble this ceiling fan, follow the steps below (Fig. 3-9):
1.
Follow the instructions in the installation section to install the mounting bracket according
to ceiling type.
2. Then take the main body of the fan and attach it to the mounting bracket as shown in
Figure 6.
3. Take the receiver and make the electrical connections by means of quick connectors. Once
connections are made, insert the receiver inside the upper part of the fan main body.
Follow the wiring instructions shown in Figure 5.
4. Unhook the fan from the hook and screw the mounting bracket to the main body. Screw the
two screws into the mounting bracket without over-tightening them. Then, attach the fan
main body to the previously fixed screws and tighten the latter. Fig. 6.
5. To install the blades, use the screws and washers supplied in the installation kit. Install
the blade making sure the pointed end faces downwards. Align the blade with the holes
on the underside of the main body and insert the screws. Repeat this step until all blades
are installed. Fig. 7
6. Connect the LED board to the two electrical connectors and fix it to the LED-board bracket
using the magnets provided on the LED board. Fig. 8-9
7.
Finally, take the lamp and screw it onto the LED board bracket as shown in Figure 10.
Warning
Self-tapping screws are only suitable for wooden ceilings. In case of installing the ceiling fan
to concrete ceilings or joists, use a drill for making the holes and plugs or expansion screws
(not included).
44
ENERGYSILENCE AERO 5600 AQUA CONNECTED | 5285 SUN CONNECTED

Publicidad

loading

Este manual también es adecuado para:

Energysilence aero 5285 sun connectedEnergysilence aero 5600 white aqua connectedEnergysilence aero 5600 black aqua connectedEnergysilence aero 5600 steel aqua connectedEnergysilence aero 5285 sun whitetransparentEnergysilence aero 5285 sun blacktransparent ... Mostrar todo