Graco SNUGLITE i-SIZE R129 Manual Del Usuario página 5

audible clicks and the colors
of the indicators on the both
ISOFIX connectors should be
9
-1
completely green.
! Check to make sure the base is
securely installed by pulling on
the both ISOFIX connectors.
After placing the base on the vehicle
seat, extend the load leg to floor,
10
When the load leg indicator shows
green means it is installed correctly,
red means it is installed incorrectly.
10
-3
! The load leg has 24 positions.
When the load leg indicator
shows red this means the load
leg is in the wrong position.
! Make sure the load leg is in full
contact with the vehicle floor
pan.
! Squeeze the load leg releasing
button, then shorten the load
leg upwards.
! Always make sure the support
load leg has direct contact
with the floor and is in locked
position even when the child is
not in it.
The completely assembled base is
shown as
11
! The ISOFIX connectors must be
attached and locked onto the
11
-1
ISOFIX anchor points.
! The load leg must be installed
correctly with green indicator.
11
-2
Push the infant carrier module down
into the base , if the enhanced
12
infant child restraint is secure, the
enhanced infant child restraint
indicator shows green.
13
! Pull up on the infant carrier
module to be sure it is securely
latched into the base.
To release the infant carrier, pull
14
-2 while
the infant carrier up
squeezing the infant carrier release
14
button. -1
To remove the base, press the
15
secondary lock button -1 first
15
-2 on the
and then the button
ISOFIX connectors before removing
the base from the vehicle seat.
Press the ISOFIX releasing button to
fold the ISOFIX. 16
7
1
2
3
15
Connecteur ISOFIX
1
Indicateur de la coque
2
Guides ISOFIX
3
Piètement de charge
4
Bouton de réglage du piètement
5
de charge A
9
8
7
4
5
6
10
Indicateur de piètement de
6
charge
Bouton de réglage du piètement
7
de charge B
Bouton de déverrouillage de la
8
coque de bébé
Déverrouillage
9
Rangement du manuel
10
d'instructions
8