CODELOCKS CL5000 NetCode Guía De Introducción página 4

Settings
Additional lock settings are available: change
lock/unlocked indicator, set the User Code
length and enable or disable the keypad sound.
Factory Reset
The lock can be reset to its original factory
settings. You may need to do this if the Master
Code is no longer known. To reset the lock, you
must have access to the battery compartment in
the rear of the lock.
Remove a battery.
1
Press and hold the 1 button.
2
Replace the battery whilst continuing to hold
3
the 1 button.
After the Blue LED flashes twice, release the
4
1 button.
Within 3 seconds, press the 1 button three
5
times.
The Blue LED will flash twice confirming that
6
the lock has reverted to the factory settings.
Troubleshooting
Incorrect Code
After three consecutive incorrect codes, the
lock will not accept further keypad input for
10 seconds.
Programming Error
If a programming mistake is made wait 5
seconds, the Red LED will flash and beep and
the lock will revert to normal.
Battery Failure
If the batteries fail, the key override can be
used to open the door. Open the battery
cover on the rear of the lock. Replace with
high quality AA batteries and ensure that they
are orientated correctly. Please refer to local
authority recommendations for the disposal of
old batteries.
Important! If set previously, the date and time
will need to be reset after replacing the batteries.
NetCode
®
settings will be retained.