Publicidad
Idiomas disponibles
Idiomas disponibles
The e-scooter requires routine cleaning and maintenance.
First, make sure the charging cable is not connected. Fasten the rubber cover of the charging port on the deck. Second, the e-
scooter must be powered off. Now you can wipe the case of the e-scooter with a soft damp cloth.
Do not use alcohol, gasoline, kerosene or other corrosive, volatile chemical solvents for cleaning or the surface and the internal
structure may be severely damaged.
Do not use a water canon to clean the e-scooter.
Avoid water or other liquids seep into the e-scooter. The internal electronics would be permanently damaged.
CAUTIONS
1.
Please refer to your local retailer if you want to replace any component.
Replacement of any component should be done by the Retailer of by authorized after-sale offices.
2.
A note specifying that the self-tightening nuts as well as the other self-tightening fastenings may lose their efficiency
and that they may need to be retightened. Please periodically check that all screws are correctly tighten.
WARNING
As with any mechanical component, a PLEV is subject to high stresses and wear. The various materials and components may
react differently to wear or fatigue. If the expected service life for a component has been exceeded, it may break suddenly,
therefore risking causing injuries to the user. Cracks, scratches, and discoloration in the areas subject to high stresses indicate
that the component has exceeded its service life and should be replaced.
WARNING
Recommendation to not make any modifications that are not noted in the manufacturer's instructions.
WARNING
Do not open the e-scooter for any reason. The user is responsible of any after-effect.
Non-professionals shall not dismantle the battery pack without permission, or severe accidents may be caused due to electric
shock or short circuit.
Maintenance of the electric kickscooter
21
Publicidad
