Publicidad
Idiomas disponibles
Idiomas disponibles
Procedure:
•
Place the stand in the prepared position
•
Place the stove on the stand using a lift or sharing the weight between several.
•
Turn the stove so that the fixing screw of the plinth cover is accessible. Unscrew the fixing screw of the
plinth cover (2 screws for the low stand and 4 for the log-store stand) and remove it. (See photo 1). This
step is not needed for the bench stand.
•
Unscrew the 2 fixing screws from the control panel and remove it (photo 2).
Photo 1
•
Pass the bolt through the stand and into the mounting hole. In the bech stand, pass the bolt through the
flue of the outside air intake system of the bench stand and put it into the mounting hole using an Allen
key (see diagram below)
•
Using the latchkey, bring the nut in front of the hole and
screw it in with the Allen key (Photo 3).
•
Replace the control panel and the base cover using the
screwdriver or screw gun.
WARNING: THE TIGHTER THE SCREW IS, THE MORE
RESISTANCE THERE WILL BE IN MOVING THE STOVE
Air intake
35
Photo 2
Photo 3
Publicidad
