Publicidad
Idiomas disponibles
Idiomas disponibles
GCY42 Connectivity Module
Installation
instructions included with Bosch GCY42
connectivity module. Operating instructions
for GCY42 connectivity module include im-
portant information not covered in this man-
ual.
tery. Do not use any other button/coin cells
or other forms of electrical power supply.
properly. There is a risk of explosion.
children. This product contains a lithium but-
ton/coin cell battery. If a new or used lithium
button/coin cell battery is swallowed or en-
ters the body, it can cause severe internal
burns and can lead to death in as little as 2
hours. If you think a battery might have been
swallowed or placed inside any part of the
body, seek immediate medical attention.
module compartment. If the connectivity
module compartment does not close secure-
ly, stop using the product, remove the bat-
tery, and keep it away from children.
'–' terminals with insulating tape. When dis-
posed of improperly, lithium batteries may
short, causing them to become hot, burst or
ignite.
to high heat. The batteries may explode.
1605A002AD GDS18V-1180C 202402.indd 13
Assembly
To reduce the risk of in-
jury read the operating
Only use Button/coin cell
3V lithium CR2032 bat-
Ensure that battery re-
placement is carried out
Chemical Burn Hazard.
Keep batteries away from
Always
completely
cure
the
connectivity
When discarding batter-
ies, insulate the '+' and
Never dispose of the bat-
teries in a fire or expose
Fig. 6
If GCY42 connectivity module is not pur-
chased with the tool, or if the replacement of
the module or the battery becomes necessary,
please follow this procedure (See Fig. 6):
— Using a flat screwdriver or a coin, remove
the cover (A) from the side of the handle,
by turning it 1/4 turn counter-clockwise.
— If the tool is already equipped with the
connectivity module, remove the battery
(B), but do not remove the connectivity
module (C).
se-
— If the connectivity module is installed for
the first time, remove the plastic place-
holder (D) from the connectivity module
compartment, and place the connectivity
module (C) in the compartment observing
correct orientation. Note: Store the place-
holder (D) in a safe place. Reinsert the
placeholder again if the communications
module is removed.
— Next place new battery (B) on the top of
the connectivity module with the "+" polar-
ity facing up.
— Place the cover (A) over the battery and
turn it ¼-turn clockwise to lock using a flat
screwdriver or a coin.
A
B
C
D
13
2/12/24 7:16 AM
Publicidad
