Publicidad
Idiomas disponibles
Idiomas disponibles
3. Ceiling Fan Assembly
3.2
Remove One of the Three #6-32 x 3/8" Pan Head
Screws with Lockwashers from the Fan Motor Hub
(Figure 2).
Retain the #6-32 x 3/8" Pan Head Screw with
Lockwasher for future use.
Loosen the Two #6-32 x 3/8" Pan Head Screws with
Lockwashers (Figure 2).
3.3
Place the 2-pin Fan Motor Assembly connector through
the large center hole of the Light Kit Adapter (Figure 3).
Position the Light Kit Adapter Key Hole Slots onto the
Two loosened Screw Heads.
Rotate the Light Kit Adapter Clockwise to engage the
Two Screws.
NOTE: Verify that the serrated washers are not
trapped between the Light Kit Adapter and the Fan
Motor Hub.
Reinstall the previously removed #6-32 x 3/8" Pan Head
Screw with Lockwasher (Figure 3).
Retighten all Three #6-32 x 3/8" Pan Head Screws with
Lockwashers to securely attach the Light Kit Adapter to
the Fan Motor Hub (Figure 3).
A spare #6-32 x 3/8" Pan Head Screw with Lockwasher
is in the hardware bag, if needed.
Carefully turn the partially assembled Ceiling Fan
right side up and position the Fan on the styrofoam in
preparation for additional assembly.
3.4
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the 6" Downrod (Figure 4).
Remove the Pin from the 6" Downrod, then remove the
Hanger Ball (Figure 4).
Retain the Pin and Hanger Ball for reinstallation in
Step 3.11.
Note: Do not loosen the screw that attaches the
green ground wire to the hanger ball.
(Continued)
Figure 2
LIGHT KIT
ADAPTER
Figure 3
PIN
PHILLIPS HEAD SET SCREW
Figure 4
(LOOSENED)
6
REMOVE AND RETAIN
ONE #6-32 x 3/8" PAN
HEAD SCREW
w/LOCKWASHER
LOOSEN TWO #6-32 x 3/8"
PAN HEAD SCREWS
w/LOCKWASHERS
REINSTALL & TIGHTEN
THE #6-32 x 3/8" PAN
HEAD SCREW
w/LOCKWASHER
RETIGHTEN THE #6-32 x 3/8"
PAN HEAD SCREWS
w/LOCKWASHERS (2)
GREEN GROUND WIRE
6" DOWNROD
HANGER BALL
ETL Model No.: CF315
Publicidad
