Descargar Imprimir esta página

Senix CSPX5-M Manual Del Operador página 10

Ion de litio de 58v máx., motosierra inalámbrica

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY
IMPORTANT: Do not over-tension the chain:
this will lead to excessive
wear and reduces the life of
both the bar and chain.
CAUTION!
The saw chain must be tensioned properly
in order to ensure safe operation.
The chain tension is optimal if the saw chain
can be lifted (2 mm) from the center of the
guide bar.
Because the saw chain heats up during
operation, its length can fluctuate. Check the
chain tension every 10 minutes of operation
and adjust as necessary, particularly for new
saw chains.
TIP: The saw chain shortens when cooling
down. Loosen the saw chain after work
is completed to elongate the chain's life
and prevent possible damage.
SAW CHAIN LUBRICATION
The pole saw features automatic chain
lubrication. Never operate the pole saw
without saw chain oil. The use of the pole saw
without enough saw chain oil will damage
the unit.
Only use special saw chain oil. Other oils will
run the risk of damaging the unit and voiding
the warranty.
Take note of temperature conditions. Using
the saw at various temperatures requires the
use of differing oils. To ensure a sufficient
layer of lubricant at lower temperatures, use
liquid oil (low viscosity).
FILLING THE OIL TANK
1. Place the saw on a level surface. Clean
the area around the oil tank cap and then
open it.
CAUTION!
Make sure that no dirt gets into the oil tank
to prevent clogging in the oil nozzle.
2. Fill the oil tank with 2.73 oz. (80 ml) of saw
chain oil (Figure 5).
Figure 5 - Oil tank
10
3. Close the oil tank cap.
ATTACH /REMOVE THE BATTERY
Only use a Senix-approved battery and
charger.
Note: The battery is not fully charged at the
time of purchase. Charge it fully before using
it for the first time.
To insert the battery, slide it into the back of
the unit until a "click" is heard. Make sure
the battery is fully inserted and latched into
position.
To remove the battery, press the release
button and slide the battery out.
Do not insert or remove the battery while
the trigger is pressed or while the chain is
in motion.
1
CAUTION!
WARNING!
WWW.SENIXTOOLS.COM

Publicidad

loading

Este manual también es adecuado para:

Cspx5-m-0