Publicidad
Idiomas disponibles
Idiomas disponibles
I
Do not install in the following types of location, otherwise this may cause malfunction:
• Locations where the temperature can exceed -10 °C or 40 °C.
• Locations where the unit may come into direct contact with water.
• Locations where the unit is under direct or strong sunlight
• Locations where there is a lot of condensation.
• Locations where corrosive, neutral, or reductive gases are present.
• Places lower than -20m or higher than 2000m above sea level.
I
Installation location
• Install somewhere the unit wlll be easy to use, as shown in the figure.
If the unit is installed too low, water may get on it when the floor is being cleaned.
• The space between the base and floor or obstacles must be more than 150 mm, because the power
operating part is at the bottom of the unit.
• Ensure there are no mirrors or walls near the two side, as drops of water may splatter to the right when
drying hands. (Recommended distance is at least 100 mm.)
• Avoid locations where people or doors might bump into the unit.
• Choose a completely flat surface on the wall to install the unit.
I
About the machine take electric way
• Suggested take electric by socket, install three hole standard socket on one wall side apart away the
machine 20-30 cm, don't installed on it below, to avoid interference to open wind door plate , must be
common ground wire to ground.
• Directly connecting to power line, please installed embedded junction box without cover.
Fixed screws
Unit
Safety screw
Drain tank
Power switch
Power supply
Installation panel
Installation heights
(Recommended)
935 mm (for man)
915 mm (for woman)
Installation panel
Air filter
Terminal box
- 19 -
Precautions before installing
Installed terminal box
Distance between the
terminal box without
cover and the ground
Publicidad
