Kieboom Laser KL850 Manual De Instrucciones página 14

3. Enable the Auto Beam Positioning by turning off ADS if it is on, and by placing the instrument
in SPOT mode. (ADS will not be available in Spot mode once it is turned off).
4. Press the Auto Beam Positioning (B) button; the laser beam will plumb down over point.
(Reference Only).
5: Use the clockwise (F) and counter-clockwise (G) buttons for fine adjustment. Plumbing /
Lay-Down (Models KL850V, and KL850GR)
NOTE: For fine adjustment of the vertical laser plane or of the 90° beam, please refer to "Line Position"
Variable Rotation Mode (Models KL850V, and KL850GR
The rotation mode will give you the option of increasing or decreasing the speed of the rotating
laser. This feature can be used to create a room-wide, 360° height reference or vertical plumb line
for general alignment, drop ceiling installation, and more.
model KL850V
Pressing the (E) button, will adjust the speed from
600, 300, 150, and 0 RPM.
model KL850GR
Using the SELECT buttons, adjust the rotation speed in increments of 50 RPM; lowest possible
speed is 100 RPM and the highest is 1000 RPM.
Sweep or Scanning Mode (Models KL850V, and KL850GR)
Instead of creating a room-wide reference line, the Sweep (Scanning) Mode creates a shorter,
brighter laser "chalk line" that can be used for leveling or plumbing doors, windows, fixtures, and
more. You may also use this feature to keep the instrument from interfering with other lasers and
detectors on site.
model KL850V
Pressing the (D) button, will lengthen or shorten the sweep of the laser beam. Preset angles of 10º,
45º, 90º,180º and spot can be set. Position the sweep area by using the (F) or (G) buttons.
model KL850GR
Using the MODE button to enter the "POSition"
option, and use the SELECT buttons to position the
sweep clockwise or ccw. Press the MODE button to
return to SWEEP SETUP. Use the right SELECT button
to enter the "LENGTH" option and use the
corresponding SELECT buttons to lengthen or
shorten the sweep of the laser beam to the
appropriate length for your application. The sweep
can be as long as 359° or as short as 3°. The last sweep setup entered remains in memory and will
be recalled.
14 • KL850 • KL850V • KL850GR
SELECT
ROTATION
SELECT
SWEEP SETUP
POS LENGTH
SWEEP SETUP
CCW CW
SWEEP POS
FAST SLOW
ROTATE 600
LONG SHORT
SWEEP LENGTH