HAMPTON BAY 99160 Guía De Uso Y Cuidado

PACKAGE CONTENTS
A
A - Fixture head x 1
Assembly and Installation
1
Attaching and installing the light
WARNING: Risk of electric shock do not install the light
within 10 ft. (3.05 m) of a pool, spa or fountain.
NOTE: Do not use a hammer. If the ground is hard, use
water to soften it or a trowel to loosen the soil.
□ Attach the fixture head (A) to the top post (B) by inserting the upper end of
the post (B) into the fixture head.
□ Insert the fixture wire (2) into the groove located on the top of the ground
stake.
□ Attach the post (B) to the stake (C) by placing the bottom of the post (B)
onto the top of the stake (C) and twisting clockwise.
□ Prepare a hole in the installation location. Use a screwdriver to prepare
the installation hole to ensure that the hole is not larger than the stake (C).
□ Install the fixture in the ground by pushing on the foot step (1) on the
stake (C). Do not push the fixture head.
1
Use and Care Guide
Black Springs
LED Low Voltage Path Light
B
B - Post x 1
A
B
2
D
C
C
C - Stake with foot step x 1
2
Connecting the wires
WARNING: The connector contacts (D) have sharp edges
for piercing the main low voltage cable. To avoid injury,
do not touch the metal contacts.
CAUTION: The wire from the low voltage power unit shall
be 12-16 AWG type underground Low Energy Circuit
Cable.
IMPORTANT:
□ Protect the wiring by routing it in close proximity to the
light, or next to a building structure such as a house or
deck.
□ Do not bury the wiring by more than 6 in. (15.24 cm) in
order to connect to the main secondary wire.
□ Do not submerge fixtures in water.
□ Have the length cut off so that it is connected to a
connector within 6 inches (15.2 cm) from a building
structure, a luminaire, or fitting.
□ Detach and place the wire connector (D) on opposite sides of the
low voltage cable (not included) where the fixture will be located.
(additional landscape lighting cable can be purchased at your local
Home Depot store).
□ Align and fit the main low voltage cable vertically in the slot of the wire
connector as shown.
□ Press the wire connector (D) together until it is fully seated and locked
around the cable. Pre-set prongs will pierce the cable insulation and
establish contact.
□ Turn on the power unit. If the light fixture does not turn on, repeat the
previous 3 steps.
□ Once the clip-on connector is in place, we recommend wrapping it in
electrical tape (not included) for additional protection.
D
Please contact 1-855-HD-HAMPTON for further assistance.
Item #1007 976 447
Model #99160
D
D - Connector with
12 in. wire length
(attached to fixture) x 1
HAMPTONBAY.COM