Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
The indicator will light up while the appliance is in operation.
-
-
Use the speed buttons to select the power level.
-
Press the power button to switch the appliance off.
-
Use the timer buttons to select the operation time of the appliance. The fan will turn off
once the selected time has elapsed.
-
Press the light button to turn the fan's lamp on and off.
-
The remote control is powered by 2 x 1.5V-3AAA batteries.
Winter/Summer function
-
Winter function: to activate winter function, press button 7, if the blades start to rotate
clockwise, this mode is activated (causing the warm air to be distributed throughout the
room), otherwise press the button again.
-
Summer function: to activate summer function, press button 7, if the blades start to
rotate counterclockwise this mode is activated (causing a cool breeze), otherwise press
the button again.
Warning
Invert the spinning direction of the fan while in operation. Hold down button 7 for approx.
3 seconds: the appliance will beep, and the blades will start slowing down until they stop
spinning. After a few seconds, they will start spinning again in the opposite direction.
Warnings
The remote control operates through RF Wireless digital transmission technology. If both
-
the fan and the lamp are equipped with a switch, turn on the fan at top speed and turn
the light on before using the remote control.
If the fan or the light cannot be controlled through the remote control, check if the
-
batteries in the remote control are in good conditions and if they make good contact, that
the positive and negative electrodes are in the correct position, and if the batteries are
charged.
-
If the fan or the light cannot be controlled through the remote control, check if there are
other remote-controlled appliances in the same area and check if the transmitter buttons
are pressed. Appliances with similar remote-control systems may cause interference.
This does not include infrared remote controls.
-
Pay attention to the appliance voltage. Too low a voltage may cause the remote control to
not work. The technical specifications are indicated in this manual.
-
If the remote control is not going to be used for a long time, remove the batteries.
Changing the remote-control battery
The remote control requires 2 x 1.5 V-3 AAA batteries.
1. Open the battery compartment.
2. Insert the batteries into the battery compartment observing the polarity.
3. Close the compartment.
50
ENERGYSILENCE AERO 5250 WHITEWOOD/ BLACKWOOD
Publicidad
