GE 20 Manual Del Propietario E Instalación página 17

Installation Instructions
[] REMOVE THE FRESH FOOD
DOOR HANDLE
(For placement in the installation location
or reversal of the handles- on some
models)
Stainless steel (on
some models):
@ REMOVING
THE DOOR
HANDLE: Loosen
the set
screws Badge
with the 3/32"
Allen wrench
and remove
the handle.
NOTE: For
Double Door
Mounting /
models follow
Fasteners
the same
(appearance may vary)
procedure on
the opposite
door,
Plastic handle
(on some models):
@ REMOVING THE DOOR HANDLE: Depress the
tab on the
underside of
_
the handle and _,_'_]"
slide the handle \.v___JJj
up and off of
the mounting
fasteners,
@ REVERSING THE
DOOR HANDLE
(on some
models):
Mounting
Fasteners
• Remove
the handle
(appearance may vary)
mounting
fasteners with a 3/16" Allen wrench and
transfer
the handle mounting fasteners to the right
side.
o
o
Remove the logo badge.
Remove and transfer the plug button to
the left side of the fresh food door. NOTE:
Use a flat plastic edge to prevent damaging
the door. Remove any adhesive on the door
with a mild detergent. Remove the paper
covering on the adhesive backing on the
logo badge prior to carefully attaching the
badge to the door.
m
17
[71 REMOVE THE FREEZER DOOR HANDLE
Stainless steel and plastic handles:
Q Loosen the set screws located on the
underside of the handle with the 1/8" Allen
wrench and remove the handle.
NOTE: If the handle mounting fasteners need
to be tightened or removed, use a 3/16" Allen
wrench.