Publicidad
Idiomas disponibles
Idiomas disponibles
KEEP THIS NOTICE
This instruction manual contains safety instructions, assembly instructions, operating
and maintenance procedures, troubleshooting, spare parts and schematics for this
device.
1. Safety instructions
1.1.
General instructions
CAUTION: When using machinery, equipment or power tools, you must always observe the following
safety precautions to reduce the risk of fire, electric shock and personal injury.
1. Use in a safe environment: There must be no risk of explosions or corrosive products in the nearby
environment during use.
2. Take into account the working area environment: Do not expose the tool to rain. Do not use the
tool in damp, wet locations or with a risk of water spray. Keep the work area well li t. Do not use the
tool in the presence of flammable liquids or gases or dust.
3. Keep a clean and orderly working area : The working area must be visible from the working
position. Messy areas and workbenches are conducive to accidents.
4. Protection against electric shock: Avoid personal contact with grounded or grounded surfaces
(e.g. pipes, radiators, cookers, refrigerators).
5. Keep other persons away: Do not allow persons, especially children, who are not involved in the
work being carried out, touch the tool or extension piece, and keep them away from the work area,
be especially careful with children and animals.
6. Store unused tools: Unused tools must be stored in a dry or locked area out of the reach of children.
7. Do not force the tool: A tool gives better results in a safer way to the regime, to the power for which
it was designed.
8. Use the appropriate tool: Do not force a small tool or accessory to perform larger work. Do not
use the tool for any purpose for which it is not designed.
9. Wear suitable protective clothing and equipment: Never wear loose clothing or jewellery, as they
may be caught by moving parts. Protective gloves are recommended. Hold long hair. Non-slip shoes
are recommended for outdoor work.
10. Use protective equipment: Use safety glasses, a normal mask or a dust mask if the work
operations generate dust, protective gloves.
11. Connect dust extraction equipment: If the tool is provided for connecting dust extraction and
recovery equipment, ensure that they are connected and used correctly.
12. Don't lean too much: Maintain good support and stay in balance at all times.
13. Treat tools with care: Keep tools clean to optimise work and safety. Follow the instructions for
lubricating and changing the accessories. Inspect their condition periodically, if necessary, have
their repair carried out at an authorised service station.
14. Stay alert: Focuss on work. Use judgement. Do not use the tool when you are tired, under the
influence of drugs, alcohol or drugs.
15. Cheque for damaged parts: Before using the tool, carefully examine the condition of the parts to
ensure that they function correctly and that they perform their task. Cheque the alignment and
freedom of operation of the moving parts, the condition and fitting of the parts and any other
conditions which may adversely affaect the operation. Any part that is in poor condition must be
repaired or replaced by an authorised service station unless otherwise indicated in this instruction
manual.
SODISE 85 Route de Pont Gwin 29510 Briec
FRANCE
EN
SODISE NIU 10434 V.2.2
8
Publicidad
