Maytag MMV4205 Instrucciones De Instalación página 12

Installation Instructions
A. RECIRCULATING (Non-Vented Ductless)
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Mount the Microwave Oven
+
AI.__. A TTACH THE MOUNTING PLATE
TO THE WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud.
1, Remove the toggle wings from the bolts.
2, Insert the bolts into the mounting plate through
the holes designated to go into drywall and
reattach the toggle wings to 3A" onto each bolt.
To use toggle bolts:
Spacing for Toggles More
Than Wall Thickness
I Toggle Wings
Mount ng =
Plate
Wall
Bolt End
3.
Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure to coincide bottom line of the
Mounting plate with Horizontal line of "Rear wall
Template" and then the Mounting plate is properly
centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the walt.
4. Tighten all bolts. Pull the plate away from the walt
to help tighten the bolts.
A2.__. USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
12