Interlogix UVP 1.3 MPX HD 18X PTZ Guia De Inicio Rapido página 5

Idiomas disponibles

Housing tab

Make sure the housing tab is closed and then PUSH the housing

into the pass-through hole. Hold the housing and fix it by screwing

the housing tabs down to the mounting surface

5. Insert the PTZ module into the housing:

Position the tabs on the PTZ module by aligning the arrow label on

the module with those on the housing (see below). The module

should firmly snap into position. If using a SDHC card, insert it into

the module before inserting the module into the housing.

6. Re-attach the bubble by screwing it to the housing.

7. Pendant-mount camera only: Route the PTZ module cables

through the bracket.

Flush mount camera only: Install the trim ring. Align the trim ring

to the housing, and insert the fix-pins to the holes. Then rotate the

ring clockwise.

8. Connect the cables (see Figure 1).

UVP 1.3 MPX HD 18X PTZ Camera

Screw

3 EN