Audi 81A.071.126 Instrucciones De Montaje página 25

3 Installing/removing carrier units
on the vehicle
3.1 Installing carrier units on the vehicle
Preparing carrier units for installation:
– Open the lock -12- using the key -11-.
– Note the key number of your roof bars. This will facilitate re-
placement in the event of loss.
– Open the cover flaps -10-.
– Connect the torque wrench -21- to the bolts -14- and un-
screw until obvious resistance is felt.
– Swivel out the claw fasteners -15- and hook the narrow end
of the claw fasteners in the installation position on the base
brackets -8-.
Note
When in the installation position, the claw fasteners -15- are a
clear distance from the support brackets.
Installation instructions - Audi Q2 (GA) 2017 ►
3 Installing/removing carrier units on the vehicle
Edition 01
7