Audi 81A.071.126 Instrucciones De Montaje página 31

– Adjust the right-hand support bracket so that the plastic base
support with roof support -18- is flush with the edge of the
roof -arrow-.
The gap -a- must not exceed 1 mm.
GTQ218
– Use a hexagon socket wrench -A- to tighten the hexagon
bolts -4- to 8 Nm.
– Push the profile cap -6- back into the profile tube -3- -B-.
– Repeat the procedure on the other roof bar if necessary.
WARNING
Check that all hexagon bolts have been tightened (8 Nm).
If these guidelines are not observed, this can result in the
carrier units becoming loose or falling off – risk of acci-
dent!
Do not use the supplied torque wrench (4 Nm).
Installation instructions - Audi Q2 (GA) 2017 ►
⇒ F ig. on page 9
ZUB-
3 Installing/removing carrier units on the vehicle
Edition 01
13