Audi 81A.071.126 Instrucciones De Montaje página 29

When the add-on components are not in use, secure the T
groove with the profile cover -1-.
– Adjust the profile cover -1- to the length of the roof bars with
the profile caps -6- closed.
– Place the profile cover -1- on the T groove in the profile tube
-3- and press the cover into the T groove
-in the direction of the arrow-.
3.3 Removing the carrier units from the ve-
hicle
Note
Remove the load and the roof rack modules.
Removing the carrier units:
– Open the lock -11- using the key -12- and open the cover
flap -10-.
– Open the vehicle doors.
– Unscrew the left and right tensioning bolts -21- alternately
using the torque wrench -14- until obvious resistance is felt.
– Slide the left and right claw fasteners -15- downward to the
stop. The positioning bolts should no longer be in the mount-
ing holes.
– Swivel the claw fasteners -15- upward and hook the narrow
end into the installation position on the base bracket -8-.
– Carefully remove the carrier units from the vehicle roof.
– Unhook the claw fasteners -15- from the installation position
and swivel downward.
– Screw in the tensioning bolt -14- by approx. 10 rotations.
– Close the cover flap -10- and lock the lock -11- with the key
-12-.
– Remove the key -12-.
3.4 Maintenance instructions
Carrier units
The carrier units must always be cleaned and kept in good order. It is particularly important to remove any
dirt and salt in the winter.
The carrier units can be cleaned using water.
Locks
Installation instructions - Audi Q2 (GA) 2017 ►
3 Installing/removing carrier units on the vehicle
Edition 01
11