Parkside PADM 1250 A1 Traduccion Del Manual De Instrucciones Originale página 33

2. Adjust the blade height by screwing/
unscrewing the two adjusting screws
(35).
Cleaning and servicing
Remove the mains plug before car-
rying out any adjustments, mainte-
nance or repair work.
Have any work on the device
that is not described in this
instruction manual performed by a
professional. Only use original
parts. Allow the device to cool off
before performing any mainte-
nance or cleaning. There is a dan-
ger of burns!
Always check the device before using it
for obvious defects such as loose, worn or
damaged parts, correct the positioning of
screws or other parts. Replace damaged
parts.
Cleaning
Do not use any cleaning agents
or solvents. Chemical substances
may attack the plastic parts of the
machine. Never clean the device
under running water.
• Thoroughly clean the machine after
every use. Remove chips, dust and
workpiece remnants with a vacuum
cleaner if necessary.
• Clean the ventilation openings and
the surface of the machine with a soft
brush or cloth.
• Try to clean resinous surfaces with a
damp, lukewarm cloth that has been
wrung out well. Make sure that no
liquids can get into the interior of the
housing!
Alternatively, you can use a special
cleaner (resin solvent) or multispray.
Please take notice of the safety informa-
tion and instructions provided by the
manufacturer of the special cleaner/
multispray.
Maintenance
The device is maintenance free.
Storage
• Store the device in a dry and dustproof
location and out of reach of children.
• The mains cable can be wound onto the
holders (30) on the back of the appli-
ance for storage, see Fig.
Transport
Caution! Hot surface. There is
a risk of burns. Only transport
the machine when it has cooled
down completely.
• The machine can be relocated over a
short distance with two people. Relocat-
ing the device over a longer distance
generally has to take place with a
transport aid.
• To carry, grip the device by the four
feet or by the feed and discharge ta-
ble.
• For stabilisation purposes, we recom-
mend installing the cross struts to se-
cure the table for transport between the
housing (11) and the feed/discharge
table (4/14) for the period of trans-
port.
GB MT
.
33