AXXAIR GA10-M1 Manual De Instrucciones página 32

INNOVATIVE ORBITAL SOLUTIONS
7. Mounting the milling head on the motor
This must be done when the machine is unplugged.
- Tighten the milling head by hand on the motor's output axis.
Lock the motor's output axis using the flat wrench supplied.
-
Tighten the milling head using the wrench supplied.
-
Wrench 1
Note:
Do not use the button mounted on the angle transmission to lock the axis because this could damage the
motor's bevel gear.
8. Mounting and adjusting stop
This must be done when the machine is unplugged.
The inserts should mill on only on the milling edge. Therefore, the insert tips must be protected.
For this purpose, we have provided guide roller that protects the tip in the direction of the tool's
axis. To protect the other side, we use the stop.
Mounting of the stop:
Fit the adjusting ring on the nut. Position the nut
assembly on the bearing, then slide the stopper into
its housing (pay attention to the mounting direction,
engraving upwards).
Screw in the nut to retract the stop.
Join experience
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
Wrench 2
330B Route de Portes Les Valence - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - commerce@axxair.com - www.axxair.com
English
- 32 -