AXXAIR GA10-M1 Manual De Instrucciones página 35

INNOVATIVE ORBITAL SOLUTIONS
Adjusting the « ZERO » position on the stop
This must be done when the machine is unplugged.
This adjustment operation is to be performed just after completing the adjustment of the position of the
penetration. In order to get the best "zero" position, follow the procedure below.
Release the profile tracking spring
GV-XXX
GJ-100
Join experience
Advance
AND turn the milling
head with the hand
to contact the cutting
edge with the tube
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
Slightly loosen the tube
the tube
CAUTION, when using a GJ-100 milling
head, contact the tip of one of the three
straight carbide tips.
The stop is used to determine the
length of the root face.
330B Route de Portes Les Valence - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - commerce@axxair.com - www.axxair.com
English
- 35 -