Descargar Imprimir esta página

Stilker 06974 Traducción De Las Instrucciones Originales página 22

Amoladora neumática

Publicidad

Idiomas disponibles

Idiomas disponibles

3.3.
Start-up
ATTENTION :
Make sure you have read and understood the instructions for use before use.
Connect the tool to a arrival of air .
-
Squeeze the trigger to operate the tool .
-
The flow air can be regulated in adjusting the valve to the end of the tool handle
-
DO NOT exert too much pressure on the tool .
To not let the tool run idle for too long a time because it would damage it .
4. Maintenance
WARNING :
Be sure to wear all required equipment when working on the tool.
To avoid serious injury, before carrying out maintenance, disconnect the tool from the
compressed air network.
-
Use appropriate protection to protect yourself during maintenance operations.
-
Regular preventative maintenance keeps tools in safe operating condition.
-
Regularly check the spindle, thread, and clamping devices for wear.
-
Check that the connections are screwed correctly, tighten them if necessary.
-
If significant loss of oil and air occurs, check the tool and have it repaired if necessary.
-
After each use, check the rotation speed and vibration level. If the level of oscillations is greater, have
the tool repaired by a specialist before continuing use.
-
Do not replace any components or modify the construction and design. If the component used is not
the same as that originally supplied by the manufacturer, the manufacturer will not be held liable.
ATTENTION :
This tool meets the corresponding safety regulations. Repairs other than those specified in this
manual should only be carried out by qualified persons.
4.1.
Performance of your tool
It is necessary to carry out a little daily maintenance: clean and lubricate regularly. Use only air tool oil.
4.2.
Air pressure
Use the fork indicated. If the pressure is too low, you will get less efficiency even in doing normal work. If
the pressure is too high, even if you obtain higher efficiency, the internal parts of the tool are easily
damaged, shortening the life of the tool.
SODISE 85 Route de Pont Gwin - 29510 Briec - FRANCE
SODISE NIU 06974 V.2.2
.
22

Publicidad

loading