Publicidad
Idiomas disponibles
Idiomas disponibles
Step 4 Connect. Link to the Wi-Fi network desired for the
connection then tap Next.
– Choose the network from the pull-down list.
– Enter password.
If the network is not listed, input the local network
to be used.
– Choose Other Network from the pull-down list.
– Enter the network name.
– Enter password.
NOTE: If your desired network is not visible, or if you
are having difficulty connecting to it, contact your
network administrator. High security networks may
require additional permissions.
How the Alert System Works
The freeze sensor measures temperature when energized by the freeze sensor activation module. The relay is activated at
37°F and stays on below 32°F.
The activation module can be connected to a building management system, irrigation management system, or Wi-Fi
network. When connected to Wi-Fi, the system can be configured to send alerts by email and text message.
Press the multifunction button for the minimum number of seconds indicated to activate a function.
Call customer service if you need assistance with technical details.
FUNCTION
PRESS (IN SECONDS)
Messages OFF
Wi-Fi ON/OFF
Reset
Test
Silences messaging. This function does not toggle. A change in conditions (such as a drop
1
in temperature) or a change to the Wi-Fi status resets this function on Messages ON.
3
Toggles the function ON or OFF.
10
Erases all temporary data.
15
Sends the Low Temperature alert during testing.
One of two outcomes is displayed:
• Setup Complete. Confirms that the freeze sensor activa-
tion module using the Wi-Fi function is successfully regis-
tered with and connected to the cloud service.
Notifications will be sent to the email address entered and
to the mobile phone number if entered.
• Could Not Connect. Indicates that the attempt to
connect to the cloud service failed. Tap OK.
Try to connect again after making sure all wiring and
cables are properly attached, the Wi-Fi function on
the activation module is enabled, the module is in range
for wireless connectivity, and the local network logon
credentials are correct. If the problem continues, submit
a request for assistance at watts.com/support or call
1-978-689-6066.
Testing the Connection
Press the multifunction button on the module for at least
15 seconds to send the message. The Low Temperature
alert is the test message.
NOTE
6
Publicidad
