FAN BASE ASSEMBLY – FIG. 1
1.
Unscrew the screw (U) from the external pole (P) and attach the external
pole (P) to the base (T) by tightening the screw (U).
2.
Remove the height adjustment knob (O) by unscrewing it
counterclockwise.
3.
Use your finger to pull out the internal pole (N), slide height adjustment
knob (O) over internal pole (N). Fasten it to external pole (P) by turning the
knob while holding the pole. Make sure the knob (O) is tightly fastened
before final assembly.
FAN HEAD ASSEMBLY – FIG. 2 & 3
1.
Remove the blade cap (B) by turning clockwise. Remove the plastic nut (D)
by turning counter clockwise.
2.
Position the rear grille (E) over the motor shaft (F), making certain that the
handle is at the top, and that the one notch on the back of rear grille (E)
fits over the three-prong attachment on the motor housing (H on parts
list).
3.
Secure rear grille (E) by turning the plastic nut (D) clockwise and tightening
firmly.
4.
Slide the fan blade (C), with the hollow interior of the blade facing toward
rear grille (E), onto motor shaft (F).
5.
Secure fan blade (C) onto motor shaft (F) by turning the blade cap (B)
counterclockwise until firmly in place.
6.
Loosen the bolt on the bottom of front grille (A) and mount the front grille
(A) with the logo right side up to rear grille (E) by snapping both together
firmly. Ensure all snaps around front grille (A) are secured onto rear grille
(E).
7.
Tighten the bolt on the bottom of front grille (A).
FINAL ASSEMBLY – FIG. 4
1.
Loosen the thumb screw (J) by turning it counterclockwise.
2.
Always keep the waterproof cover (L) match with the height adjustable
knob (O) when adjusting the internal pole (N).
3.
Insert internal pole (N) into the neck joint and tighten by turning thumb
screw (J) clockwise. Make sure it is tight enough to support the fan head.
4.
Attach the Misting Line holder (M) onto the Internal pole (N).
5.
Secure the Misting Line (Q) to the clip under front grille (A) and the misting
line clip (M)
www.newair.com
EN
11