Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING & MAINTENANCE
1.
Disconnect from the electrical socket during cleaning or initial assembly.
2.
To ensure adequate air circulation to the motor, keep the vents at the rear
of the motor housing clear of dust, dirt, etc. Unplug the fan before using a
vacuum cleaner or compressed air to clean the grilles. It should not be
necessary to disassemble the fan to clean it.
3.
Wipe the exterior housing of the fan with a soft cloth soaked in a mild
detergent. Do not use any abrasive detergents or solvents to avoid
damaging the surface. Do not use gasoline, thinner, or bending to clean
the fan.
4.
Do not allow water or any other liquid into the motor housing or interior
parts.
5.
When dismantling the fan (we recommend following the assembly
instructions in reverse), be sure to clean each of the components before
storage. Allow all parts to dry completely before storing.
6.
To test the GFCI feature, press the "TEST" button. The fan should
immediately shut off as if the GFCI has been tripped. Press the "RESET"
button and the fan should be able to be turned on again, and the light on
the GFCI box should light up orange. If it does, then the unit (as well as the
GFCI feature) are functioning normally.
7.
If the fuse in the power cord plug needs to be replaced, follow these
instructions:
a) Pull the power plug from the outlet, being careful not to pull from the
cord.
b) Slide open the fuse access cover.
c)
Remove the fuse slowly and carefully by inserting a small tool into the
fuse slot and prying it out. When one side of the fuse has been lifted
out, you will be able to remove it entirely.
d) Only replace the fuse with 5 Amp / 125
Volt fuses. Using an incompatible fuse may
cause a fire.
e) Close the fuse cover.
f)
Caution: Do not attempt to replace the
plug or the power cord itself. Only replace a broken fuse with a
compatible fuse. If any part of the plug or cord are damaged, contact
customer service for assistance.
www.newair.com
EN
13
Publicidad
