12.5.2
Feet
There are different feet (3 bigger feet and 1 small foot).
To level your device, adjust the small foot at the bottom of the appliance.
12.5.3
The handle installing
The wine cooler comes with one metal stainless steel handle. To install simply screw them to
the door with the supplied screws.
To do this, slide the rubber seal on the back of the door to the side to lay open the predrilled
holes. Use the included screws to install the handle on the door.
12.5.4
Shelves
Storrage depending on kind of bottle and size.
You can remove each shelf to store larger bottles.
Removal of shelves:
Remove all bottles from the shelves.
Removal of the fixed shelves:
Carefully pull out the shelf until this is no longer possible.
Look at the shelf rail from the side.
You see a lever. There are 2 positions
1 = below - release with pressure at point A upwards
2 = up - release with pressure at point A down
Reach into the rail with one finger and change the position of the lever by pressing the lever.
Hold this new position of the lever appropriately on both sides of the shelf and then pull out
the shelf.
Installation of the shelves:
Put the shelf back into the rail and slowly push it in until it clicks into place.
32