Publicidad
Idiomas disponibles
Idiomas disponibles
Inspect guide bar before sharpening chain. A worn
or damaged guide bar is unsafe. A worn or damaged
guide bar will damage chain. It will also make cutting
harder.
LUBRICATE SPROCKET
WARNING: Wear heavy duty gloves when
performing any maintenance or service to
this tool. Always remove the battery pack
before performing any service or maintenance on
this tool.
NOTE: It is not necessary to remove the chain or bar
when lubricating the guide bar sprocket.
1. Clean the bar and sprocket
2. Using a grease gun, insert the tip of the gun
into the lubrication hole and inject grease until it
appears at the outside edge of the sprocket tip.
(See Fig. Q)
Q
EN
3. To rotate the sprocket pull the chain by hand until
the ungreased side of the sprocket is in line with
the grease hole. Repeat the lubrication procedure.
SHARPENING SAW CHAIN
WARNING: Remove the battery pack before
servicing. Severe injury or death could
occur from electrical shock or body contact
with moving chain.
Cutting edges on chain are sharp. Use protective
gloves when handling chain.
Keep chain sharp. Your saw will cut faster and more
safely. A dull chain will cause undue sprocket, Guide
Bar, chain, and motor wear. If you must force chain
into wood and cutting creates only sawdust with few
large chips, chain is dull.
Before sharpening, please pay attention of the
following steps:( See Fig R1)
18
Injecting grease to lubricate
Inyectando grasa para lubricar
Injectez la graisse pour lubrifier
R1
a
25
o
a:Filing angle; b:file position
How to sharpen the cutters
1. Prepare a round file to sharpen the cutters.(See
Fig R2).Note:Firmly clamp the guide bar in a
vice before sharpening the chain. Ensure that
the chain is not "nipped" and can freely move on
the guide bar. Check that the chain is properley
tensioned. (See "Tensioning Chain" section)
R2
2. Sharpen the cutters with file from the inner side
of cutting teeth towards the outside of the chain.
(See Fig R3)
R3
b
o
0
5/32" 4.0mm
Publicidad
