Manual Preset; Tuning Into A Preset Station - JVC KD-LX100 Manual De Instrucciones

Manual preset

You can preset up to 6 stations in each band (FM1,
FM2, FM3 and AM) manually.
Ex: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the band (FM1).
2
Tune into a station of 88.3 MHz.
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
Band number and "MEMO" appear
alternately for a while.
10
1 Press SOURCE to
select the tuner as the
source.
2 Press BAND repeatedly
to select the FM1 band.
¢ to tune into
Press
stations of higher frequencies.
Press 4
to tune into
stations of lower frequencies.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to the
memory circuit is interrupted (for example, during battery
replacement). If this occurs, preset the stations again.

Tuning into a preset station

You can easily tune into a preset station.
Remember that you must store stations first. If you
have not stored them yet, see "Storing stations in
memory" on pages 9 and 10.
1
Select the band.
1 Press SOURCE to select
2 If necessary, press
Each time you press the button, the band
changes as follows:
FM1 FM2
2
Select the number (1 – 6) for the preset
station you want.
When using this unit in an area other than
North or South America:
You need to change the AM/FM channel
intervals. See "To change the AM/FM
channel intervals – AREA" on page 19.
tuner as the source.
BAND repeatedly to
select the band.
FM3 AM