Publicidad
Idiomas disponibles
Idiomas disponibles
TRANSPORTATION
Transporting the trimmer
1. Switch off the trimmer and remove the battery.
2. When transporting your trimmer by hand, hold
the middle of the shaft with the cutting head
to the rear and make sure that your machine is
parallel to the ground.
3. When transporting your trimmer in a vehicle,
secure and position it to prevent movement or
damage.
Transporting the battery
1. Ensure the battery is in a safe condition.
2. Use non-conductive packaging when
transporting the battery.
3. The contained Li-Ion batteries are subject to the
dangerous goods legislation requirements.
Transport batteries only when the battery
housing is undamaged. Pack up the batteries in
such a manner that cannot move around in the
packaging.
MAINTENANCE
WARNING! Always remove battery before
conducting any maintenance on the
trimmer.
Replacing the trimmer head (See Fig. J)
WARNING! Use of wire or metal-reinforced
line is not authorized and could be
extremely dangerous. Use only the cutting line
recommended in this manual, in combination
with the recommended debris guard.
WARNING! A damaged or loose cutting
attachment head may vibrate, crack, break
or come off the trimmer, which may result in
serious or fatal injury or property damage. Make
sure the trimmer head are properly and securely
tightened and in good condition before starting
work.
J
1. Insert the torx key into the hole and rotate the
trimmer head until it stops in a locked position.
2. Then, rotate clockwise to remove it, and
counterclockwise to assemble it. (See Fig. A1)
Winding the line (See Fig. K1, K2, K3)
1. Rotate the spool cap until the two triangle icons
are alighted. (See Fig. K1)
K1
K2
K3
2. Insert the replacement line through the eyelet
(Line In) and feed it out through the other eyelet.
Ensure both ends of the line are even on each
end of the trimmer head (recommended
6.5 ft (2 m) and cut the line. (See Fig. K2)
EN
2 m
(6.5 ft)
2 m
(6.5 ft)
13
Publicidad
