Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
When Adding Fuel
• Stop the engine. Let engine cool at least 2
minutes before removing the gas cap.
• Fill fuel tank outdoors or in well-ventilated
area.
• Do not overfill fuel tank. Fill tank to
approximately 1-1/2 inches below top of neck
to allow for fuel expansion.
• Keep gasoline away from sparks, open
flames, pilot lights, heat, and other ignition
sources.
• Check fuel lines, tank, cap, and fittings
frequently for cracks or leaks. Replace if
necessary.
• If fuel spills, wait until it evaporates before
starting engine.
When Starting Engine
• Make sure spark plug, muffler, fuel cap and air
cleaner are in place.
• Do not crank engine with spark plug removed.
• If engine floods, set choke to OPEN/RUN
position, place throttle in FAST and crank until
engine starts.
When Operating Equipment
• Do not tip engine or equipment at angle which
causes gasoline to spill.
• Do not choke carburetor to stop the engine.
Move the throttle control to the stop position to
stop the engine.
When Transporting Equipment
• Transport with fuel tank EMPTY or with fuel
shut-off valve OFF.
When Storing Gasoline Or Equipment With
Fuel In Tank
Store away from furnaces, stoves, water
heaters or other appliances that have pilot
light or other ignition source because they can
ignite gasoline vapors.
WARNING
• If there is natural or LP gas leakage in area, do
not start engine.
• Do not use pressurized starting fluids because
vapors are flammable.
WARNING
• Start and run engine outdoors.
• Do not start or run engine in enclosed area,
even if doors or windows are open.
WARNING
• Before starting the engine, make sure to raise
the blade.
• When starting engine, pull the starter cord
slowly until resistance is felt, then pull rapidly.
• Remove all external equipment/engine
loads
before starting engine.
• Direct-coupled equipment components such as,
but not limited to, blades, impellers, pulleys,
sprockets, etc., must be securely attached.
Publicidad
