Craftsman 536.772360 Manual Del Usuario página 9

How To Raise The Handle
1 Loosen the knobs (A) and raise the upper handle
(B) to the upright position. See Figure 2.
2 Tighten the knobs. Make sure the knobs are to the
outside of the handles as shown in Figure 2.
Figure 2: Handle Assembly
Insert the end of the control rod (C), from RIGHT
to LEFT, through the hole in the front wheel arm
(D). Attach with the hair pin (E) found in the parts
bag. See Figure 3.
Figure 3: Lower Control Rod Assembly
4
5
Push down on the handle to tilt the unit back.
Insert the other end of the control rod, from RIGHT
to LEFT, through the hole in the depth control lever
(F) and fasten with the hair pin. See Figure 4.
Figure 4: Upper Control Rod Assembly
6
7
8
Move the depth control lever forward to the
STARTING and TRANSPORT position.
Remove any packing material from the bottom of
the unit.
Twist the starter rope (G) through the rope guide
(H). See Figure 5,
Figure 5: Starter Rope
_- Assembly Checklist _"
For the best performance and satisfaction from this
quality product, please review the following checklist _'
before you operate the product: _,
_' All assembly instructions have been completed.
Check carton. Make sure no loose parts remain
in the carton.
All fasteners have been properly tightened.
Add engine oil to the engine. See "Before
Starting The Engine" in the Operation Section.
9