Descargar Imprimir esta página

cecotec ENERGYSILENCE AERO 5200 LIGHT WHITE Manual De Instrucciones página 49

Ventilador de techo con motor dc de 30w
Ocultar thumbs Ver también para ENERGYSILENCE AERO 5200 LIGHT WHITE:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 37
NOTE: be sure to press the power button for 30 seconds before pairing the remote control,
otherwise you will not be able to pair it.
2. If you notice that the transmitter does not control the receiver, check that the batteries
are inserted correctly and that they are not dead.
3. This may also be due to the proximity of similar products that also operate with a remote
control, which, if they use the same frequency, could cause interference.
4. If the batteries in the remote control are dead, replace them so that you can continue to
use it normally.
5. Remove the batteries from the remote control if you are not going to use it for a long
period of time.
6. Make sure that the earth wire is properly connected.
7. When positioning the fan, make sure that no wires are pinched. If this happens, a short-
circuit may occur.
Reminder
-
The receiver must be correctly installed in the fan mounting bracket.
-
Remove the batteries from the remote control if you are not going to use it for a long
period of time.
-
The isolation switch must be switched on.
-
If the power is cut off (e.g. due to a blackout) the light will go out. When the power is
restored, the light will switch on again.
Receiver protection functions
-
The DC motor has a built-in safety feature against blade or motor obstruction during
operation.
-
During operation: if an object obstructs the fan blades or the fan motor, the motor will
attempt to run for 30 seconds and then stop running. Remove obstructions and restart
the motor. To restart it: switch the fan off from the remote control and then switch it on
again.
-
The device will limit the maximum current output from the receiver/drive if the fan load
has increased abnormally.
Recommendations
-
If your fan runs automatically when you switch it on for the first time after installation, it
has memorised the previous factory setting.
-
If the fan or light does not work, reset the fan. To do this, turn it off for at least 5 seconds
and then turn it on again.
-
It is not possible to control more than one fan in the same room if they share the same
power supply. If you want to separately control more than one fan in the same room, you
must use separate power supplies.
ENERGYSILENCE AERO 5200 LIGHT WHITE / BLACK
ENGLISH
49

Publicidad

loading

Este manual también es adecuado para:

Energysilence aero 5200 light black0862008621