Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
Before using the Floorwasher, fill the clean water cup with tap water (do not exceed the MAX
line marked on the cup).
NOTE: You can fill the cup with warm water; however, do not use water with
temperature over 60 degrees.
While pressing the clean water cup release button downward, pull to remove the cup.
Open the lid and fill the cup with tap water. Do not allow water to exceed the MAX
line marked on the cup overflow the cup with water.
NOTE: For deep cleaning, replace 16ml of tap water with neutral floor
liquid detergent (to be purchased separately).
Close the lid and make sure the cup is closed tight and no leakage.
Place the clean water cup back to the main body, and then push the cup in until it
clicks into place.
Power on the Floorwasher
1.
Press the On/Off button
2.
Tilt the Floorwasher backward to start cleaning.
NOTE:
•
When standing upright, the Floorwasher will be powered off even if you press
the On/Off button.
•
Do not tilt the Floorwasher over 150 degrees. Doing so might result in water
leakage from the water cups.
Power off the Floorwasher
•
Press the On/Off button
Switch modes
1.
While the Floorwasher is powering on and cleaning the floor, you can press
handle to switch to Power mode
on the handle to power on the Floorwasher.
<150º
on the handle.
.
10
EN
on the
Publicidad
