Publicidad
Idiomas disponibles
Idiomas disponibles
5. Hold down " Delay" button and then press "Program" button for 5 seconds. The buzzer
rings one time and H. flashes on the digital display. (factory setting is H4).
To change the setting:
1. Press " Delay " button.
Each time the button is pressed, the set value increasesby one level; when the value of
H7 has been reached, the display jumps back to H0(off).
2. Press " Program " button. The chosen setting has now been stored
Contact your local water board for information on the hardness of your water suplly.
Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
energy consumption increases by 0.001kWh.
WATER HARDNESS TABLE
Water hardness
Clark
0-8
9-10
11-12
13-15
16-20
21-26
27-38
39-62
B. LOADING THE SALT INTO THE SOFTENER
Always use salt intended for use with dishwasher.
NOTE: If your model has no water softener, you may skip this section.
The hardness of the water varies from place to place. If hard water is used in the
dishwasher, deposits will form on the dishes and utensils.
The appliance is equipped with a special softener that uses salts specifically designed to
eliminate lime and minerals from the water.
The salt container is located beneath the lower basket and should be filled as follows:
Mmol/I
Range
Soft
0-1.1
Soft
1.2-1.4
Médium
1.5-1.8
Médium
1.9-2.1
Médium
2.2-2.9
Hard
3.0-3.7
Hard
3.8-5.4
Hard
5.5-8.9
WATER SOFTENER
Set value on the
machine
H0
H1
H2
H3
H4
H5
H6
H7
77
.
Regeneration occurs
every x programme
sequence
Off
13
9
7
5
4
2
1
Publicidad
