Functional Description; Adjusting The Shoe - Makita JR1000FT Manual De Instrucciones

Sierra recíproca
Ocultar thumbs Ver también para JR1000FT:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

only when hand-held.
11.
Always switch off and wait for the blade to
come to a complete stop before removing the
blade from the workpiece.
12. Do not touch the blade or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
13. Do
not
operate
unnecessarily.
14. Always use the correct dust mask/respirator
for the material and application you are
working with.
15. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
the
tool
at
no-load
USD201-2

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.

Adjusting the shoe

CAUTION:
Secure the shoe firmly after reposition the shoe.
1
3
006231
006232
When the blade loses its cutting efficiency in one place
along its cutting edge, reposition the shoe to utilize a
sharp, unused portion of its cutting edge. This will help to
lengthen the life of the blade.
To reposition the shoe, peel off the cover and loosen the
clamping screw with the hex wrench as shown in the
figure.
Slide the shoe forward or back to the desired position,
then tighten the clamping screw to firmly secure the
shoe.
1
006233
4
1. Clamping screw
2
2. Cover
3. Shoe
1. Hex wrench
1
1. Shoe

Publicidad

Tabla de contenido
loading

Tabla de contenido