Publicidad
Idiomas disponibles
Idiomas disponibles
CODE LINKING/DELETING THE RADIO REMOTE CONTROL
The code pairing of the radio remote control has already been successfully
completed at the factory. (Info: The infrared remote control does not generally
have to be paired.)
To disconnect the screen from the mains for 10 seconds and then reconnect it
to the mains. Within the next 10 seconds, press the up and stop buttons on the
radio remote control simultaneously. If the process was successful, the motor
moves forward briefly and then back again. The code adjustment is now com-
plete. The deletion process is carried out with the code adjustment. One status
replaces the other with the same procedure.
Up
Paper clip
Stop
Adjustment button for extension height
Down
Up(fine)
Down (fine)
Fig. 5
Remote control
SETTING THE STOP POINT / HEIGHT OF THE BLACK DROP
Caution: The black drop must only be set with the remote control. The black
drop can be easily adjusted after the projector and screen have been positi-
oned so that the projected image is aligned with the screen. The adjustment
is for fine tuning only and NOT to compensate for general height differences.
This must already be adjusted when installing the units (e.g. height of the
screen on your wall or back wall of furniture, height of your projector on the
sideboard or in a lower drawer / pull-out).
The rope tensioning system is designed in such a way that a concave cut of
the projection screen edges from the bottom to the top ensures that lateral
tension is applied along the entire length of the fabric, and this is the only way
13
Publicidad
