Publicidad
Idiomas disponibles
Idiomas disponibles
•
Due to the special mechanics of this type of screen, it is possible that there
is a minimal difference in height from the left to the right side. Correct this
using your projector or the adjustable feet of the screen.
•
If the flap does not close when the screen is retracted, raise the screen
fabric again and turn the trigger for the flap electronics on the back a
maximum of two turns anti-clockwise so that it can be triggered by the
lowering screen.
Flatness of the fabric:
•
The black drop must be in the range of min. 250 mm - max. 400 mm. to
maintain the flatness.
•
Do not change the feed on the motor, as this will change the digital setting
that controls the extension height and may permanently adjust or damage
your product.
•
Do not touch the screen fabric with your fingers. The material is very sen-
sitive and because of its surface coating can only be cleaned to a limited
extent. This cannot be avoided due to the screen technology.
•
The fabric, like all thermoplastics, is naturally subject to material deforma-
tion with decreasing or increasing room temperature. Slow temperature
changes that affect the product as a whole, as usually occur indoors, are
harmless. (e.g. as they occur with the change of seasons). Make absolutely
sure that the product and especially the extended fabric, are not subject to
different temperatures at different points. This uneven temperature effect
would „strain" the material, as colder areas deform differently than warmer
areas, which would very likely result in your ultra-short distance projection
showing distortions in the image. (e.g. sunlight, placed directly on a radia-
tor, on air outlets or intakes of any air conditioners, other heat generating
AV components such as AV receivers, game consoles or computers).
Trigger for the flap electronics
16
Publicidad
