Publicidad
Idiomas disponibles
Idiomas disponibles
Parts no supplied
Tools/Materials required
Level
•
Drill
•
.1" (3.0 mm) drill bit
•
Pencil
•
Pliers
•
Tape measure or ruler
•
Caulking gun and weatherproof caulking compound
•
Flat-blade screwdriver
•
Phillips screwdriver
•
Saber or keyhole saw
•
Metal snips
•
Vent clamps
•
Parts needed
• 6" (15.2 cm) round metal vent system
LOCATION REQUIREMENTS
IMPORTANT: Observe all governing codes and ordinances.
Have a qualified technician install the range hood. It is the
installer's responsibility to comply with installation clearances
specified on the model/serial rating plate.
Range hood location should be away from strong draft areas,
such as windows, doors, and strong heating vents.
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance. Consult your
cooktop/ range manufacturer installation instructions before
making any cutouts.
Grounded electrical outlet is required.
See "Electrical Requirements" section.
The range hood is factory set for vented installations through
the roof or wall. For non-vented (recirculating) installations
see "Non- Vented (recirculating) Installation Through the
Soffit/Cabinet" in the "Prepare Location" section.
Recirculation Kit Part is available from your dealer or an autho-
rized parts distributor. All openings in ceiling and wall where
range hood will be installed must be sealed.
For mobile home installations
The installation of this range hood must conform to the
Manufactured Home Construction Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction and Safety, title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured
Home Installation 1982 (Manufactured Home Sites, Communi-
ties and Setups) ANSI A225.1/NFPA 501A, or latest edition, or
with local codes.
®
†
TORX is a registered trademark of Saturn Fasteners, Inc.
4
Optional accessories and consumable parts
KIT
Carbon Filter Kit
Up to 30" width
Hood Liner
Product dimensions
B
A
I* - Metallic spacers
Spacers has to be
installed and used
when cabinet depth
is greater than 12".
A
B
C
D
E
F
G
H
I*
For gas range installation: Mount this hood so that the bottom
edge is at minimum 30"(76.2 cm) above the cooking surface.
For electric range installation: mount this hood so that the
bottom is not less than 24"(61 cm).
# Part
28.5" (72.39 cm)
KIT0184665
Up to 36" width
KIT02773
KIT02774
H
G
F
E
D
C
I*
Model
EAS328SS
28.2" (71.8 cm)
26" (66 cm)
1.1" (2.9 cm)
10.7" (27.3 cm)
9.5" (24.2 cm)
0.3" (.95 cm)
14.5" (37 cm)
6" (15.2 cm)
0.5" (1.27 cm)
I*
Publicidad
